It is recommended to place your door/window contact sensor DWC-102 as high up as possible on the door and the door frame respectively.
1. Carefully remove the activation strip from the battery compartment.
2. Remove the backing paper from one side of each self-adhesive double-sided strip. Fix one strip to the back of the Magnet and one to the back of the Transmitter.
3. Peel off the other side of each adhesive strip. Mount the Magnet on the door/ window and the Transmitter on the door/window frame, with less than a 1 cm separation between the two. The alignment triangles on the sensor and the magnet should be in close proximity on the same level horizon when the door/ window is closed.
4. When opening the door, a small led indicator lights up briefly, this indicates that the Transmitter has sent a signal to the Control Panel.
